Fishing for Cutthroat Trout

Experienced fishermen know all about the cutthroat trout. That is because it is a huge gaming fish and it is difficult to catch. Why, then do so many fisherman go cutthroat trout fishing? These fish can be big and they offer a great flavor no matter if you plan to smoke, fry, or bake it. Cutthroat trout are some of the best fish to be caught. The cutthroat trout is also known by other names...

Continue Reading...

Salmon Fishing - Professional Tips

Salmon Fishing General salmon information and fishing tips: 1. Generally, the best times of the day are during the times when there is low light and so too, on cloudy days. On bright and sunny days, salmon will usually collect and assemble deep in the holes. 2. Take note that salmon do not feed while in the river. When they do strike, it is a behavior that is learned. Salmons are...

Continue Reading...

Fishing Equipment Tips

Frank Faldo


Cheap Sinkers
Spark plugs make excellent disposable sinkers. Need some cheap (free) fishing weights? Go to any gas station and ask for them. Then, loop a rubber band through the electrode and then tapping the wire down the plug can be attached to a loop of monofilament. The rubber band stretches when the plug is hung up, and even if the extra stretching force isn’t enough to break free, the band will break before the monofilament.
*Special Tip - An amazing secret many fishermen don't know about is The Evening Secret. It is an amazing way of swarming fish to your spot instantly. (http://www.eveningsecretfishing.com/specialsec ret/Fishing_Equipment_Tips.php)
Jig Weights
Jigs are one of the most versatile game-fish catchers in either fresh or saltwater. It is so important to have the right weight jig for your line weight. If the jig is too heavy for the line, you will loose your jig far too easily. If the jig is too light for the line, its swimming pattern will be disrupted and it won’t be ass effective. This simple chart will help you select the correct jig:
Line Strength Jig Size 4-lb. Test 1/16 to 1/8 oz. 6-lb. Test 1/8 to ¼ oz. 8-lb. Test ¼ to 3/8 oz. 10-lb. Test ¼ to ½ oz. 12-lb. Test 3/8 to 5/8 oz. 14 to 20-lb. Test 5/8 to ¾ oz Treble Hook Replacement
When replacing the treble hooks on your lures, there are a few things to consider. Chang the split ring too because it is subject to stress and rust. Use a stainless-steel split ring for strength. They do not spread or rust as to most of those that come wit h the plugs. Don’t, however, use stainless steel hooks – they are more easily bent out of shape by a fighting fish. Also, if a fish gets away with your plug, stainless steel will not rust out, as a plain steel hook will. Lastly, get some split-ring pliers – they make changing your hooks easy.
Extra Springs
If you use a spinning reel, you have probably had a spring break when the fishing gets really hot. Always carry extras (use a 35mm-film canister) – and make sure to have a little screwdriver along as well. Practice changing it before you go out
No-slip Soles
If your winter boot soles are worn, just cut the liner to match the sole of an old sneaker. Fasten the felt to the sneaker sole with a non-soluble glue. Please a heavy object on top of the sneaker overnight, and by morning you have an all purpose non-slip shoe.
Snag-proof Spinners
Treble hooks are oftentimes “trouble” when using spinners, causing snags. Make them snag-free by removing the treble hook and replace with a single hook. Next thread on a three to four inch twister-tail grub and Texas-rig it.
Downriggers
Need to drop your bait down deep? Fish are very uncooperative creatures, and don’t always hang out near the surface. If your depth sounder is alerting you to fish down deeper, a downrigger can really help out.
If you aren’t exactly sure what it is, it is simple. It is a spool holding between 200-600 feet of steel cable. There is a weight attached that is between 6-12 pounds. Additionally there is a quick-release line gripper, just like a clothespin.
The fishing lines from your rods are attached to the quick-release mechanisms. Then the entire thing is dropped down to the depth you want. The bait is far enough from the weight and line gripper not to spook the fish. If you get a bite, the line is released from the gripper, so it is just you and the fish!
Some downriggers have fish-attractant properties (either electrical, or a special kind of paint), but not most of them.
Downriggers work great for deep trolling, and some even have an electronic crank that will bring everything up. If you need to get at deeper schools of fish, these are highly recommended.
Nail Polish Helps
Does your spoon, spinner, or plug get the paint chipped after only a few casts? Use clear fingernail polish to protect the paint and increase durability. Carry a bottle with you when you are fishing, and give it a shot.
Ferrules
If there is dirt on your ferrule it can contribute to rapid wear. Make a plug out of wood to help keep the female ferrule clean.
Is your ferrule stuck? Use “Liquid Wrench”, which you can get at any auto-parts store. Just spray it around the male ferrule and let it drip down. In a few minutes you will be able to pull it apart.
Getting Out Line Tangles
Use a pair of large fabric needles to work out these tangles. They have a smooth finish which won’t damage the line as you work the mess out. They are also handy to sew canvas tarp, leather, or carpet strips.
Pocket Tackle box
Attach a cord to your pocket tackle box, so you don’t worry about dropping it in the water or leaving it behind. Just drill an undersized hole near the back of the box and insert a small eye-screw. A know will stop the cord from slipping through the eye. Just put a clip on the other end so that you can secure the rope to a belt loop or buttonhole.
Avoiding Line Twist
Line twist is the leading cause of fouled fishing. To check for it, pull off enough line to span your outstretched hands – about 6 feet. Next, bring your hands together in front of you, causing the line to drop into a loop. If the loop wraps around itself, you have line twist. Remove it by trolling about 100 feet of line behind a boat. Next install a ball-bearing swivel to prevent future line twist.
Knots Are Key
One of the most important things in losing or landing a hooked fish is your knot. Be certain the knot you are tying is strong and properly tied.
To make sure, tie your usual knot and test it against other knots. A good test is to take two four-inch sections of a broom handle with the screw eye in the center of each. Tie a knot in each screw eye and pull steadily until you see which knot survives. Do it 10 times to get an average. The knot that holds best should be your new knot.
Anchor Pulley, Keep it Quiet
If you use an anchor pulley, you risk spooking the fish as most pulleys eventually start to squeak. Try this alternative to a pulley:
Get a large U-bolt, a few nuts and washers, and an old-style glass or porcelain fencepost insulator.
Slip the insulator on a U-bolt, drill a couple of holes to accommodate the bolt, and tighten it to the mounting surface. The anchor rope will slide freely in the insulator’s groove, and the anchor lowers and raises as effortlessly as with a pulley, especially once the rope is wet.
Casting Poppers
Casting poppers with a fly rod is awkward. To get better distance bore a slightly undersized small hole in the popper, just big enough to fit a BB in. It should fit snugly and will give you another 30 feet of casting distance at least.
Cheap and easy depth finder
Using two felt-tipped markers (red and black) mark an anchor rope as follows: A single red mark around the rope at five feet, a red and black mark at 10 feet, a single red mark at 15 feet, two black marks at 20 feet, a single red and two black marks at 25 feet and three black marks at 30. Use the color code red for every five feet and multiples of black for 10 feet.
Netting baitfish
Increases the efficiency of your minnow scoop by putting a bend in it. Just turn the wire handle down 90 degrees, then push the net back on line. The forward-positioned net makes it much easier to trap a baitfish against the inside of an open-top bucket.
A Cheap Anchor For A Fishing Boat
For holding a good-sized boat over a rocky bottom, use a large swivel snap to fasten four fee of heavy chain to a standard mushroom anchor. You can get one from a junkyard. The chain boosts the anchor’s weight and holding power, provides convenient handles for lowering and raising, and gives extra leverage when an anchor jams in rocks or snags. When he brings it aboard, he coils the heavy chain on a bed of old foam-rubber pads so it doesn’t rattle around or dent his boat. In calm water, he simply unsnaps the chain and uses the mushroom anchor by itself.
About the author: Copyright 2005 EveningSecretFishing.com Fishing
Long-Time Fisherman and friend of EveningSecretFishing.com (http://www.eveningsecretfishing.com/specialsec ret/Fishing_Equipment_Tips.php)
Feel free to use this article on your website or anywhere else - but all links and bio information must remain in tact.

Kayak Fishing Trips

Tips on Kayak Fishing It takes a long time to become an expert in kayak fishing. The period of apprenticeship, which must be served in order to transform the novice into a veteran kayak angler can be discouraging and often runs into years. About the nearest thing to a short cut is to have an old-timer take the first-timer under his wing and let the novice accompany him on kayak fishing trips Basically, kayak fishing is gradually making a name in the industry. Its popularity is steadily creating sustainable gratifications aside from the fact that kayaks have long been used in fishing. History...

Continue Reading...


The latest information and news on Fishing:

Google
Fishing uncommonly good in some parts
Fishing's been pretty good for anglers able to get around the rains.
Fishing report: Sept. 9
FISHING REPORT
Fishing contest planned Saturday in Corunna
CORUNNA ? A fishing contest with four age categories has been added to the Kith & Kin gala Saturday.
Fishing report: High winds make Michigan lakes tough for anglers
LANSING -- The fishing prognosis for this week doesn't sound any better than last week, the Michigan Department of Natural Resources and Environment said in its weekly fishing report.
Fishing Report by Tony Mathos ? September, 2010
I was lucky enough to go fishing twice this week. My first stop was for an evening fishing adventure at Lake Hogan in Calaveras County. Hogan is a great Mother Lode fishing destination that has been overlooked for years.
Fishing ban lifted
Sri Lanka has lifted all restrictions for fishing imposed due to LTTE terrorism making the country?s territorial waters free and open for fishing.
Fishing report (Sept. 9-15)
Courtesy Connecticut DEP INLAND REPORT LARGEMOUTH BASS fishing is variable, ranging slow to good. The best reports are from Candlewood Lake, Mudge Pond, Amos Lake (best at night) and Mamanasco Lake, with fair reports from Lake Wononskopomuc, Bantam Lake (very mixed reports), Quaddick Reservoir (a bit on the tough side, but catches include a 5.7 lb largemouth), Crystal Lake (Ellington), Cedar ...
Fishing gear over the years has improved a lot
The sport of fishing in Arkansas is much changed over the past several decades. Technical advances have been coupled with increased knowledge on the part of anglers.
Fishing training school to close
ONE of the few remaining port based fishing industry training centre?s on the East Coast is to close because its funding has been cut. The Seafood Training Centre in North Shields says it is losing its main £250,000 funding grants and regretfully will have to close its doors in North Shields.
Fishing Report: Saltwater opportunities are available
Some different saltwater fishing opportunities are opening up for Central Coast fishermen just as th

Using a Fishing Rod

Rods are basically made from carbon. Plastic, composite carbon combined with Kevlar, which is a kind of material that is bullet proof, or just high carbon. Since the carbon's force and strength in connection to its mass is light, making it strong material that can allow thinner fabrication but still is able to keep the span and length. A rod that is lighter evidently handling will be easier, controlling it would be less tiring on ones arms and reduces resistance to air giving one an easier time accurately casting it, particularly on windy ways. Rods come in silicon carbide, hard chrome...

Continue Reading...